To install, position the club head in the cover with the outside edge of the club head touching the tab on the back of the cover. Holding the club head and cover with cupped hands, push the clamp downward into the slot with your thumbs.

The serrated part of the clamp should engage the teeth on the front side of the cover.  Repeat for the second clamp.  Then push both clamps a little further so that they are tight on the upper back of the club head.

Watch video below, if you want to see hands-on instruction

To remove the clamp, grasp the tab protruding off the back of the club head between your thumb and forefinger, pull it down slightly and rotate it 90 degrees in either direction to disengage the teeth on the front of the cover and then slide the clamp up the slot and off.  If the clamp doesn’t want to easily rotate out in one direction, try rotating the other direction.

Watch video below, if you want to see hands-on instruction

Quickly and easily attach your putting adapter to your club cover: hold the adapter in one hand and the club cover in the other, align, and gently slide it in until secure.

Watch video below, if you want to see hands-on instruction.